#Realistic 2006 scanner how to

A battery with a capacity of nine Amp hours (Ah) is more than adequate for this scanner. The scanner is easily operated using an inexpensive, lightweight and rechargeable Sealed Lead Acid (SLA) battery. An HF receiver or modern outboard conversion hardware (such as RadiØKit-2 in combination with open source Dream software) is required to demodulate the SSB from the IF signal.īeing relatively lightweight, the PRO-2006 offers genuine potential during field trips at summits. These include the ability to tap the discriminator output or the 455 kHz third Intermediate Frequency (IF) signal for SSB demodulation. There are plenty of modifications that can be undertaken for this scanner. The scanner sold for a retail price of $400 in the United States. A rooftop antenna or whip (supplied) is connected via the BNC antenna connector. This triple conversion receiver offers microprocessor-controlled VHF, UHF and FM reception. It is also known in Europe as the Commtel COM-205 or Handic 0080 (below), according to Javiation. It was manufactured for Tandy by General Research of Electronics, Inc. Looks like the Pro-2022 can't cover the Military Air band (225-380 MHz AM mode) so no monitoring of military aircraft at all but it could be used for listening into local Civilian Air band from 118-137 MHz AM mode without any issues at all.Around 1990, Tandy Corporation introduced the Realistic PRO-2006 programmable scanner. If it still works you can find a use for it, absolutely, but it more than likely has so many limitations compared to newer hardware. As long as what you might want to monitor - even the digital formats - is using conventional style channels/frequencies (that stay the same) and not trunking systems (where the comms can hop frequencies) there's potential for monitoring.īasically it's good for the stuff that's not quite as popular as in most areas of the US and the rest of the world are moving towards using digital hardware more often than not, especially any kind of law enforcement/police agencies, fire and EMS agencies, and government related whether it's city, state, or Federal.

#Realistic 2006 scanner how to

If that scanner can be tapped aka a discriminator tap is installed meaning you or someone that knows how to do it can install a cable that will connect to the discriminator circuit to provide the raw baseband signal (the pure radio signal unfiltered) you could then feed that signal into a computer's sound card which would then be able to pass the signal to software like DSD+ which is a Windows-based application that decodes digital formats and you'd get some more use from that scanner. If however the comms you want to monitor have switched over to using digital radio equipment and digital formats like P25, DMR, NXDN, or whatever then no that scanner won't be of much use but but but.

The simple question is: do you have analog communications in your area happening that you'd like to monitor? If the answer is yes, and the scanner works as designed, then you're good to go.